Product description
Park Tool FR-1.3 Sprocket Remover 5-10 for Screw-On Casette
12 splines, 22.6mm diameter fits Shimano, Sachs Aris, Sun Race, DNP Epoch and other 5–10 speed freewheels. The FR-1.3 includes an enlarged thru-hole to accommodate 14mm axles. Base of tool can be installed in a vise or used with a 1" socket or wrench.
Details
- suitable for Shimano, Sachs, Aris, SunRace, DNP Epoch and other crowns
- suitable for up to 14 mm hollow axles
Features
The delivered product may have been produced earlier than the advertised model year.
Purpose
MTB Beginner / Tour, Marathon / Cross Country, All Mountain / Enduro, All-round / Beginner, Tour / Cross Country, Marathon / XC, All Mountain / Trail, Enduro, Trekking, Bike Travel, Cross, Every Day / Commuting, Lifestyle / Urban Biking, Everyday Cycling, Lifestyle / Single Speed, Urban Sports, Commuting
The delivered product may have been produced earlier than the advertised model year.
Main Information
Tool Type:
Puller
Operating Range:
Cassette / Hub
The delivered product may have been produced earlier than the advertised model year.
Scope of Delivery
Delivery:
1 x Park Tool FR-1.3 Freewheel Remover for 5-10 speed freewheels
The delivered product may have been produced earlier than the advertised model year.
Model Year
2024
The delivered product may have been produced earlier than the advertised model year.
Article number
574676
Manufacturer article number
FR-1,3
EAN
0763477003447
Customer opinions
Florian
inch size!!!
Translated from the German
To the original
I have an overall top impression of this tool. Very stable, fits perfectly.
BUT: Where in Germany can you find a 1" wrench? Yes, that's right, it's not a metric hexagon. With an adjusting wrench I got 25 mm, but it's slightly too small and I can't find a 1" wrench in any German hardware store . Also not in the range of Fahrrad.de. Would be useful to mention that in the description of the item.
17.03.2022
Ronny
tiptop
Translated from the German
To the original
Small but fine, reliably fulfills its purpose. Good price
04.03.2022
Laurent
Suitable for VAE rear motor (Bafang)
Translated from the French
To the original
The bore is large enough (unlike the shimano tool) to run the cables from the rear motor through the frame of a bafang (or other) hub motor.
It may eventually be necessary to disassemble and replace the hall effect sensor connector which, in any case, is too big to pass through the cassette
21.01.2022