Supernova Z-Reflector 2 for Fender red
ID: 1337935
£8.89
Unfortunately the desired product is currently sold out
Product description
Supernova Z-Reflector 2 for Fender red (red)
Thanks to different rubber adapters that nestle against the mudguard and perfectly compensate for the curvature, the Z-REFLEKTOR 2 is suitable for a wide range of mudguard shapes. Can be ideally combined with the Supernova Tail Lights!
Features
The delivered product may have been produced earlier than the advertised model year.
Purpose
Trekking, Bike Travel, Every Day / Commuting, Lifestyle / Urban Biking, Bikepacking, Everyday Cycling, Commuting, Lifestyle / Single Speed, Urban Sports, Cross
The delivered product may have been produced earlier than the advertised model year.
Main Information
Type:
reflector
The delivered product may have been produced earlier than the advertised model year.
Scope of Delivery
Delivery:
'Z-reflector for mudguards, Including narrow and wide rubber and short screw'
The delivered product may have been produced earlier than the advertised model year.
Model Year
2023
The delivered product may have been produced earlier than the advertised model year.
Article number
1337935
EAN
4260224791115
Customer opinions
Markus
Fastening is defective!
Translated from the German
To the original
The reflector initially makes a good and valuable impression. Attached it carefully according to the instructions.
However, if you often drive on unpaved roads, the screw loosens extremely quickly. There are a maximum of 4 to 5 thread turns in the cast-in plastic thread.
Great for the seller, he will always have his sales with it.
Very annoying for the customer.
The only remedy is hot glue or silicone.
Inevitably I have to buy the same junk again because now I only have the right holes in the fender.
Stay away and rather buy something of higher quality.
29.06.2022
Ilmo
Good reflector
Translated from the Finnish
To the original
Great reflector for the rear fender. Installation a bit tedious, but works well when you follow the installation instructions. Requires two holes for the fender, screw and positioner pin. Comes with two rubber molds for narrow and wide fenders that fit the curvature of the reflector fender. The narrow one worked well on my bike, the installation became neat and the reflector stays firmly in place. The only drawback is the washer coming under the screw, which has an unnecessarily large hole in relation to the screw, and the washer does not fit neatly under the screw. However, this is hidden under the fender, so there is no big drawback.
26.02.2022