Park Tool CCP-22C Crank Removal Tool M22x1
ID: 226497
£28.99
Unfortunately the desired product is currently sold out
Product description
Park Tool CCP-22C Crank Removal Tool M22x1
The CCP-22 can be used to remove cranks with square, power drive or power spline bottom brackets. The long handle and the extra fine thread offer favourable lever ratios for loosening the most stubborn cranks. The rotating tip ensures gentle material handling and long durability.
Details
- Fits all cranks with 22 mm x 1 thread
- Suitable for Power Spline cranks from SRAM
- Fits BNI cranks on Bosch e-bikes
- Strong system with rotating tip
- Note: for cranks using the ISIS Drive or Octalink system, please use CCP-44 or CWP-7
Features
The delivered product may have been produced earlier than the advertised model year.
Purpose
MTB Beginner / Tour, Marathon / Cross Country, All Mountain / Enduro, Downhill / Freeride, All-round / Beginner, Tour / Cross Country, Marathon / XC, All Mountain / Trail, Enduro, Dirt, Road, Cyclocross, Gravel, Endurance, Trekking, Bike Travel, Cross, Every Day / Commuting, Lifestyle / Urban Biking, Everyday Cycling, Lifestyle / Single Speed, Urban Sports, Commuting, Dirt / BMX
The delivered product may have been produced earlier than the advertised model year.
Main Information
Tool Type:
Puller
Operating Range:
Crank
The delivered product may have been produced earlier than the advertised model year.
Scope of Delivery
Delivery:
1 piece
The delivered product may have been produced earlier than the advertised model year.
Model Year
2024
The delivered product may have been produced earlier than the advertised model year.
Article number
226497
Manufacturer article number
CCP-22
EAN
0763477001245
Customer opinions
Tompa
A must
Translated from the Swedish
To the original
A must if you are going to Mecca with the bicycle.
However, this model is only for 4-edge crank bearings
(JIS as ISO) - however with the reservation that with JIS the thread (center pin) has difficulty getting attached.
This is because JIS has a different thread pitch (smaller center bolt).
ISO (square edge) c: a 12.5mm
JIS (chamfered/profiled)= 12.63mm (c: a- depending on the manufacturer)
I myself have used this for both types.
However, I think that, regardless of ISO/JIS, the thread feels a little raw at first (difficult to thread), but it usually subsides after 2-3 times.
Always tighten with a spanner (22mm)!
In terms of quality, you get what you pay for.
Of course the steel is better than that from China, but for my own part I have cracked 3 pcs (the center spike).
Precisely because the thread was slow, but maybe it should be a safety thing.
21.04.2022
Sebastian
Stable and worth every penny.
Translated from the Swedish
To the original
Good quality and more pleasant to use than similar tools from the budget category. Do you like to tinker with bikes and do a lot for yourself, it's clearly a tool that should be in the toolbox.
16.06.2016
Christian
All previous reviews is a lie
Translated from the Finnish
To the original
The above four reviews. The two have been translated from Dutch, and two from Germany.
They are not, therefore, no one Finnish not entered, but the product manufacturer or merchant, all by yourself.
Voisko such should adware rating removes the fuck out of here?
08.04.2016